U2947 Subaru 1400 OBD Code

OBD/2 U2947 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

Circuit High Input codes like U2947 are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.

U2947 Subaru 1400 Error Code Repair Process :

For throttle/petal position sensor/switch c circuit malfunction check engine light is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. U2947 error code diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks throttle/petal position sensor/switch c circuit malfunction with your car's computers to find out exactly what's prompting the light to turn on.

Common Causes of Subaru 1400 U2947 OBD2 Code

A common cause of code U2947 is the failure of Throttle/Petal Position Sensor/Switch C Circuit Malfunction, but there are several other possible causes as well, such as ;

Damaged VCT phaser
Erratic camshaft position due to low oil pressure
1Camshaft Position Sensor circuit poor electrical connection
Damaged ECM

U2947 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

U2947 Subaru 1400 OBD Code

U2947 Subaru 1400 Error Code Repair Process :

Common Causes of Subaru 1400 U2947 OBD2 Code

U2947 code for other Subaru cars