U2947 Subaru Outback 2 OBD Code

OBD/2 U2947 error code description and symptoms.

Fuel Rail Pressure Sensor in Range But Low The comprehensive component monitor (CCM) monitors the FRP pressure for acceptable fuel pressure. The test fails when the fuel pressure falls below a calibrated value. Low fuel pressure Damaged FRP sensor Excessive resistance in circuit Low or no fuel A FRP PID value below 551 kpa (80 psi) indicates a failure Low or no fuel A FRP PID value greater than 896 kpa (130 psi) indicates a failure.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

U2947 Subaru Outback 2 Error Code Repair Process :

The rule of U2947 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of throttle/petal position sensor/switch c circuit malfunction. Likewise, overriding the OBD U2947 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Subaru Outback 2 U2947 OBD2 Code

A common cause of code U2947 is the failure of Throttle/Petal Position Sensor/Switch C Circuit Malfunction, but there are several other possible causes as well, such as ;

Erratic camshaft position due to low oil pressure
Continuous oil flow to the VCT piston chamber
Faulty ignition coil (s)
Continuous oil flow to the VCT piston chamber

U2947 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2947 Subaru Outback 2 OBD Code

U2947 Subaru Outback 2 Error Code Repair Process :

Common Causes of Subaru Outback 2 U2947 OBD2 Code

U2947 code for other Subaru cars