U2947 Subaru 1.8 OBD Code

OBD/2 U2947 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

U2947 Subaru 1.8 Error Code Repair Process :

If your throttle/petal position sensor/switch c circuit malfunction check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U2947 and engine control unit are in charge of monitoring a bunch of different throttle/petal position sensor/switch c circuit malfunction, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Subaru 1.8 U2947 OBD2 Code

A common cause of code U2947 is the failure of Throttle/Petal Position Sensor/Switch C Circuit Malfunction, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Damaged VCT phaser
Camshaft Position Sensor harness is open or shorted
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted

U2947 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2947 Subaru 1.8 OBD Code

U2947 Subaru 1.8 Error Code Repair Process :

Common Causes of Subaru 1.8 U2947 OBD2 Code

U2947 code for other Subaru cars