U2111 Holden Wb OBD Code

OBD/2 U2111 error code description and symptoms.

HO2S Sensor Circuit Malfunction (HO2S-11) During testing the HO2S Heaters are checked for opens/shorts and excessive current draw.
The test fails when current draw exceeds a calibrated limit and/or an open or short is detected. Short to VPWR in harness or HO2S. Water in harness connector. Open VPWR circuit. Open GND circuit. Low battery voltage. Corrosion or poor mating terminals and wiring Damaged HO2S heater. Damaged PCM.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

U2111 Holden Wb Error Code Repair Process :

The rule of U2111 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of a/c post heater sensor #2 circuit short to ground. Likewise, overriding the OBD U2111 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Holden Wb U2111 OBD2 Code

A common cause of code U2111 is the failure of A/C Post Heater Sensor #2 Circuit Short to Ground, but there are several other possible causes as well, such as ;

Exhaust tube
Engine Control Module (ECM)
Fuel injectors may be faulty
Oil Control Valve (OCV) circuit is open or shorted

U2111 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2111 Holden Wb OBD Code

U2111 Holden Wb Error Code Repair Process :

Common Causes of Holden Wb U2111 OBD2 Code

U2111 code for other Holden cars