U2111 Holden Ht OBD Code

OBD/2 U2111 error code description and symptoms.

The input turbine speed sensor detects rotation of the input shaft of the input shaft speed sensor transmission. The computer uses that information, along with the output shaft speed sensor to determine if the transmission is operating according to plan. If the computer detects a difference between the input shaft speed , and the expected output shaft speed, it will adjust transmission pump pressure to prevent clutch disc slip. If adding pressure doesn't solve the problem, it will set a trouble code.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

U2111 Holden Ht Error Code Repair Process :

The rule of U2111 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of a/c post heater sensor #2 circuit short to ground. Likewise, overriding the OBD U2111 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Holden Ht U2111 OBD2 Code

A common cause of code U2111 is the failure of A/C Post Heater Sensor #2 Circuit Short to Ground, but there are several other possible causes as well, such as ;

Faulty Air Flow Meter
Faulty Camshaft Position Sensor
Faulty select solenoid
Improper ignition timing

U2111 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2111 Holden Ht OBD Code

U2111 Holden Ht Error Code Repair Process :

Common Causes of Holden Ht U2111 OBD2 Code

U2111 code for other Holden cars