U2111 Holden Clubsport OBD Code

OBD/2 U2111 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

U2111 Holden Clubsport Error Code Repair Process :

The scent may U2111 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such U2111, so if the inside of your car a/c post heater sensor #2 circuit short to ground as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Common Causes of Holden Clubsport U2111 OBD2 Code

A common cause of code U2111 is the failure of A/C Post Heater Sensor #2 Circuit Short to Ground, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Engine Control Module (ECM)
Intake Valve Timing Control Solenoid Valve harness is open or shorted
Oil flow restriction in the oil passages or the VCT valve body

U2111 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2111 Holden Clubsport OBD Code

U2111 Holden Clubsport Error Code Repair Process :

Common Causes of Holden Clubsport U2111 OBD2 Code

U2111 code for other Holden cars