U2111 Holden Eh OBD Code

OBD/2 U2111 error code description and symptoms.

The Throttle Position sensor signals the Engine Control Module as to the current position of the engine throttle valve.
The current throttle valve opening is based on the driver's input from the gas pedal. The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

U2111 Holden Eh Error Code Repair Process :

If your vehicle failed a U2111 test and the U2111 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses a/c post heater sensor #2 circuit short to ground a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look a/c post heater sensor #2 circuit short to ground: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Common Causes of Holden Eh U2111 OBD2 Code

A common cause of code U2111 is the failure of A/C Post Heater Sensor #2 Circuit Short to Ground, but there are several other possible causes as well, such as ;

Damaged ECM
Clogged or faulty fuel injector (s)
Incorrect fuel filler cap used
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1

U2111 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2111 Holden Eh OBD Code

U2111 Holden Eh Error Code Repair Process :

Common Causes of Holden Eh U2111 OBD2 Code

U2111 code for other Holden cars