C1302 Lincoln Zephyr OBD Code

OBD/2 C1302 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

On some transmissions, such as automated manual transmissions or automatic transmissions with manual mode, the GSP switch lets the TCM know whether or not the driver has selected automatic or manual function. On manual transmissions, the GSP switch informs the TCM which gear the driver is selecting, and may function as a neutral safety switch, depending on system design. The TCM also uses the gate select position switch to monitor transmission operation. For example, if the driver selects manual mode and selects 3rd gear on an automatic transmission, the TCM may monitor speed sensors to detect clutch and brake slippage.

C1302 Lincoln Zephyr Error Code Repair Process :

For vaps solenoid actuator output circuit open check engine light is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. C1302 error code diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks vaps solenoid actuator output circuit open with your car's computers to find out exactly what's prompting the light to turn on.

Difficulty Level (Expert)

Repair Time (60 Min.)

Cost Prediction : $ 25-45

Common Causes of Lincoln Zephyr C1302 OBD2 Code

A common cause of code C1302 is the failure of VAPS Solenoid Actuator Output Circuit Open, but there are several other possible causes as well, such as ;

• Engine Control Module (ECM)
• Engine Control Module (ECM)
• Faulty variable valve timing (VVT)
• Variable Valve Timing (VVT) circuit is open or shorted

C1302 is a kind of Chassis Trouble Code Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C1302 code for other Lincoln cars

You can view according C1302 DTC for your car model. We selected several models to see obd2 solutions click and view it.

• C1302 Lincoln 47 Hp
• C1302 Lincoln Aviator
• C1302 Lincoln Blackwood
• C1302 Lincoln Capri
• C1302 Lincoln Continental
• C1302 Lincoln Cosmopolitan
• C1302 Lincoln Ls
• C1302 Lincoln Mark
• C1302 Lincoln Mark Lt
• C1302 Lincoln Mkr
• C1302 Lincoln Mks
• C1302 Lincoln Mkx
• C1302 Lincoln Mkz
• C1302 Lincoln Navigator
• C1302 Lincoln Neiman
• C1302 Lincoln Premiere
• C1302 Lincoln Sentinel
• C1302 Lincoln Town Car
• C1302 Lincoln V8

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved