C1302 Lincoln Navigator OBD Code

OBD/2 C1302 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the DVOM on the voltage setting. You will want to test the fuses with circuits loaded. Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.

C1302 Lincoln Navigator Error Code Repair Process :

For vaps solenoid actuator output circuit open check engine light is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. C1302 error code diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks vaps solenoid actuator output circuit open with your car's computers to find out exactly what's prompting the light to turn on.

Difficulty Level (Expert)

Repair Time (60 Min.)

Cost Prediction : $ 25-45

Common Causes of Lincoln Navigator C1302 OBD2 Code

A common cause of code C1302 is the failure of VAPS Solenoid Actuator Output Circuit Open, but there are several other possible causes as well, such as ;

• Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
• Damaged ECM
• Fuel Injectors circuit poor electrical connection
• Camshaft advance mechanism binding (VCT unit)

C1302 is a kind of Chassis Trouble Code Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C1302 code for other Lincoln cars

You can view according C1302 DTC for your car model. We selected several models to see obd2 solutions click and view it.

• C1302 Lincoln 47 Hp
• C1302 Lincoln Aviator
• C1302 Lincoln Blackwood
• C1302 Lincoln Capri
• C1302 Lincoln Continental
• C1302 Lincoln Cosmopolitan
• C1302 Lincoln Ls
• C1302 Lincoln Mark
• C1302 Lincoln Mark Lt
• C1302 Lincoln Mkr
• C1302 Lincoln Mks
• C1302 Lincoln Mkx
• C1302 Lincoln Mkz
• C1302 Lincoln Neiman
• C1302 Lincoln Premiere
• C1302 Lincoln Sentinel
• C1302 Lincoln Town Car
• C1302 Lincoln V8
• C1302 Lincoln Zephyr

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved