U3423 Peugeot Tulip OBD Code

OBD/2 U3423 error code description and symptoms.

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

U3423 Peugeot Tulip Error Code Repair Process :

If your wastegate control valve performance check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U3423 and engine control unit are in charge of monitoring a bunch of different wastegate control valve performance, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Peugeot Tulip U3423 OBD2 Code

A common cause of code U3423 is the failure of Wastegate Control Valve Performance, but there are several other possible causes as well, such as ;

EVAP canister or fuel tank leaks
Faulty front heated oxygen sensor
1Camshaft Position Sensor circuit poor electrical connection
Damaged camshaft position (CMP) sensor

U3423 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3423 Peugeot Tulip OBD Code

U3423 Peugeot Tulip Error Code Repair Process :

Common Causes of Peugeot Tulip U3423 OBD2 Code

U3423 code for other Peugeot cars