U3423 Peugeot Tepee OBD Code

OBD/2 U3423 error code description and symptoms.

Fuel Rail Pressure Sensor in Range But Low The comprehensive component monitor (CCM) monitors the FRP pressure for acceptable fuel pressure. The test fails when the fuel pressure falls below a calibrated value. Low fuel pressure Damaged FRP sensor Excessive resistance in circuit Low or no fuel A FRP PID value below 551 kpa (80 psi) indicates a failure Low or no fuel A FRP PID value greater than 896 kpa (130 psi) indicates a failure.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

U3423 Peugeot Tepee Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U3423 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If wastegate control valve performance so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the wastegate control valve performance.

Common Causes of Peugeot Tepee U3423 OBD2 Code

A common cause of code U3423 is the failure of Wastegate Control Valve Performance, but there are several other possible causes as well, such as ;

Erratic camshaft position due to low oil pressure
Faulty ignition coil (s)
Fuel injector leaks
EVAP canister or fuel tank leaks

U3423 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3423 Peugeot Tepee OBD Code

U3423 Peugeot Tepee Error Code Repair Process :

Common Causes of Peugeot Tepee U3423 OBD2 Code

U3423 code for other Peugeot cars