U3423 Peugeot 406 OBD Code

OBD/2 U3423 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

U3423 Peugeot 406 Error Code Repair Process :

For wastegate control valve performance check engine light is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. U3423 error code diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks wastegate control valve performance with your car's computers to find out exactly what's prompting the light to turn on.

Common Causes of Peugeot 406 U3423 OBD2 Code

A common cause of code U3423 is the failure of Wastegate Control Valve Performance, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Engine Control Module (ECM)
Damaged camshaft position (CMP) sensor
Faulty front heated oxygen sensor

U3423 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3423 Peugeot 406 OBD Code

U3423 Peugeot 406 Error Code Repair Process :

Common Causes of Peugeot 406 U3423 OBD2 Code

U3423 code for other Peugeot cars