U20E5 Mazda Protege OBD Code

OBD/2 U20E5 error code description and symptoms.

HO2S Sensor Circuit Malfunction (HO2S-11) During testing the HO2S Heaters are checked for opens/shorts and excessive current draw.
The test fails when current draw exceeds a calibrated limit and/or an open or short is detected. Short to VPWR in harness or HO2S. Water in harness connector. Open VPWR circuit. Open GND circuit. Low battery voltage. Corrosion or poor mating terminals and wiring Damaged HO2S heater. Damaged PCM.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

U20E5 Mazda Protege Error Code Repair Process :

The rule of U20E5 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of column reach feedback potentiometer circuit short to ground. Likewise, overriding the OBD U20E5 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Mazda Protege U20E5 OBD2 Code

A common cause of code U20E5 is the failure of Column Reach Feedback Potentiometer Circuit Short to Ground, but there are several other possible causes as well, such as ;

Exhaust tube
Damaged ECM
Fuel injectors harness is open or shorted
Faulty Intake Valve Timing Control Solenoid Valve

U20E5 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U20E5 Mazda Protege OBD Code

U20E5 Mazda Protege Error Code Repair Process :

Common Causes of Mazda Protege U20E5 OBD2 Code

U20E5 code for other Mazda cars