U20E5 Mazda Lantis OBD Code

OBD/2 U20E5 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

U20E5 Mazda Lantis Error Code Repair Process :

For column reach feedback potentiometer circuit short to ground check engine light is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. U20E5 error code diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks column reach feedback potentiometer circuit short to ground with your car's computers to find out exactly what's prompting the light to turn on.

Common Causes of Mazda Lantis U20E5 OBD2 Code

A common cause of code U20E5 is the failure of Column Reach Feedback Potentiometer Circuit Short to Ground, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty front heated oxygen sensor
Continuous oil flow to the VCT piston chamber
Faulty Camshaft Position Sensor

U20E5 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U20E5 Mazda Lantis OBD Code

U20E5 Mazda Lantis Error Code Repair Process :

Common Causes of Mazda Lantis U20E5 OBD2 Code

U20E5 code for other Mazda cars