The input turbine speed sensor detects rotation of the input shaft of the input shaft speed sensor transmission. The computer uses that information, along with the output shaft speed sensor to determine if the transmission is operating according to plan. If the computer detects a difference between the input shaft speed , and the expected output shaft speed, it will adjust transmission pump pressure to prevent clutch disc slip. If adding pressure doesn't solve the problem, it will set a trouble code.
A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the DVOM on the voltage setting. You will want to test the fuses with circuits loaded. Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.
The rule of U0701 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of pump rotor control underfueling. Likewise, overriding the OBD U0701 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.
Difficulty Level (Expert)
|
Repair Time (60 Min.)
|
| Cost Prediction : $ 80-170 |
|
U0701 is a kind of Network Trouble Code
U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason. |
You can view according U0701 DTC for your car model. We selected several models to see obd2 solutions click and view it.
Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.
Copyright 2017 © All rights reserved