U0701 Mercedes Cls 350 OBD Code

OBD/2 U0701 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the DVOM on the voltage setting. You will want to test the fuses with circuits loaded. Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.

U0701 Mercedes Cls 350 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U0701 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If pump rotor control underfueling so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the pump rotor control underfueling.

Common Causes of Mercedes Cls 350 U0701 OBD2 Code

A common cause of code U0701 is the failure of Pump Rotor Control Underfueling, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Failures of clutch motion/travel sensors.
Faulty Intake Valve Timing Control Solenoid Valve
Spark plugs may be faulty

U0701 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U0701 Mercedes Cls 350 OBD Code

U0701 Mercedes Cls 350 Error Code Repair Process :

Common Causes of Mercedes Cls 350 U0701 OBD2 Code

U0701 code for other Mercedes cars