U0701 Mercedes Cls 500 OBD Code

OBD/2 U0701 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

U0701 Mercedes Cls 500 Error Code Repair Process :

If your pump rotor control underfueling check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U0701 and engine control unit are in charge of monitoring a bunch of different pump rotor control underfueling, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Mercedes Cls 500 U0701 OBD2 Code

A common cause of code U0701 is the failure of Pump Rotor Control Underfueling, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty variable valve timing (VVT)
Faulty oil control valve (OCV)

U0701 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U0701 Mercedes Cls 500 OBD Code

U0701 Mercedes Cls 500 Error Code Repair Process :

Common Causes of Mercedes Cls 500 U0701 OBD2 Code

U0701 code for other Mercedes cars