C3838 Porsche 804 OBD Code

OBD/2 C3838 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C3838 Porsche 804 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine C3838 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If adaptive mode switch circuit failure so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the adaptive mode switch circuit failure.

Difficulty Level (Soso)

Repair Time (30 Min.)

Cost Prediction : $ 75-90

Common Causes of Porsche 804 C3838 OBD2 Code

A common cause of code C3838 is the failure of Adaptive Mode Switch Circuit Failure, but there are several other possible causes as well, such as ;

• Camshaft Position Sensor harness is open or shorted
• Exhaust tube
• Faulty front heated oxygen sensor
• Faulty Fuel injector

C3838 is a kind of Chassis Trouble Code Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C3838 code for other Porsche cars

You can view according C3838 DTC for your car model. We selected several models to see obd2 solutions click and view it.

• C3838 Porsche 1300
• C3838 Porsche 3400
• C3838 Porsche 356
• C3838 Porsche 550
• C3838 Porsche 718
• C3838 Porsche 901
• C3838 Porsche 904
• C3838 Porsche 906
• C3838 Porsche 907
• C3838 Porsche 908
• C3838 Porsche 910
• C3838 Porsche 911
• C3838 Porsche 911 Type 991
• C3838 Porsche 911 Type 996
• C3838 Porsche 911 Type 997
• C3838 Porsche 912
• C3838 Porsche 914
• C3838 Porsche 917
• C3838 Porsche 924
• C3838 Porsche 928
• C3838 Porsche 930
• C3838 Porsche 931
• C3838 Porsche 935
• C3838 Porsche 936
• C3838 Porsche 937
• C3838 Porsche 944
• C3838 Porsche 959
• C3838 Porsche 962
• C3838 Porsche 964
• C3838 Porsche 965
• C3838 Porsche 968
• C3838 Porsche 986
• C3838 Porsche 993
• C3838 Porsche 996
• C3838 Porsche Boxster
• C3838 Porsche Boxster Type 981
• C3838 Porsche Boxster Type 986
• C3838 Porsche Boxster Type 987
• C3838 Porsche Carrera Gt
• C3838 Porsche Cayenne
• C3838 Porsche Cayenne Type 92a
• C3838 Porsche Cayenne Type 9pa
• C3838 Porsche Cayman
• C3838 Porsche Cayman Type 718
• C3838 Porsche Cayman Type 981
• C3838 Porsche Cayman Type 987
• C3838 Porsche Coupe
• C3838 Porsche Dp
• C3838 Porsche Gt
• C3838 Porsche Gt2
• C3838 Porsche Gt3
• C3838 Porsche Karisma
• C3838 Porsche Kremer
• C3838 Porsche Macan Type 95b
• C3838 Porsche Mega
• C3838 Porsche Panamera Type 970
• C3838 Porsche Panamericana
• C3838 Porsche Rsk
• C3838 Porsche Tapiro

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved