U3708 Nissan Z Concept OBD Code

OBD/2 U3708 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

U3708 Nissan Z Concept Error Code Repair Process :

If your vehicle failed a U3708 test and the U3708 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses sbds interactive codes a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look sbds interactive codes: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Common Causes of Nissan Z Concept U3708 OBD2 Code

A common cause of code U3708 is the failure of SBDS Interactive Codes, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
EVAP system hose leaking
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Camshaft Position Sensor harness is open or shorted

U3708 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3708 Nissan Z Concept OBD Code

U3708 Nissan Z Concept Error Code Repair Process :

Common Causes of Nissan Z Concept U3708 OBD2 Code

U3708 code for other Nissan cars