U3459 Peugeot 208 Ii OBD Code

OBD/2 U3459 error code description and symptoms.

HO2S Sensor Circuit Malfunction (HO2S-11) During testing the HO2S Heaters are checked for opens/shorts and excessive current draw.
The test fails when current draw exceeds a calibrated limit and/or an open or short is detected. Short to VPWR in harness or HO2S. Water in harness connector. Open VPWR circuit. Open GND circuit. Low battery voltage. Corrosion or poor mating terminals and wiring Damaged HO2S heater. Damaged PCM.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

U3459 Peugeot 208 Ii Error Code Repair Process :

The rule of U3459 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of fuel pulse in range but lower than expected. Likewise, overriding the OBD U3459 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Peugeot 208 Ii U3459 OBD2 Code

A common cause of code U3459 is the failure of Fuel Pulse In Range But Lower Than Expected, but there are several other possible causes as well, such as ;

Exhaust tube
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Fuel injectors harness is open or shorted
Faulty TCM or TCM programming

U3459 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3459 Peugeot 208 Ii OBD Code

U3459 Peugeot 208 Ii Error Code Repair Process :

Common Causes of Peugeot 208 Ii U3459 OBD2 Code

U3459 code for other Peugeot cars