U2741 Renault Megane 2 OBD Code

OBD/2 U2741 error code description and symptoms.

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

U2741 Renault Megane 2 Error Code Repair Process :

If your scp (j1850) invalid or missing data for remote button control check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U2741 and engine control unit are in charge of monitoring a bunch of different scp (j1850) invalid or missing data for remote button control, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Renault Megane 2 U2741 OBD2 Code

A common cause of code U2741 is the failure of SCP (J1850) Invalid or Missing Data for Remote Button Control, but there are several other possible causes as well, such as ;

EVAP canister or fuel tank leaks
Continuous oil flow to the VCT piston chamber
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Exhaust tube

U2741 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2741 Renault Megane 2 OBD Code

U2741 Renault Megane 2 Error Code Repair Process :

Common Causes of Renault Megane 2 U2741 OBD2 Code

U2741 code for other Renault cars