U2741 Renault 20 OBD Code

OBD/2 U2741 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

As long as the throttle plate remains closed, the idling speed and quality is controlled by the PCM via the idle control valve, and as can be seen from the above it should be clear that idle control on a gasoline engine is a complex affair. For instance, if the engine is started in sub-zero temperatures, the PCM will command the idling control valve to allow less air to enter the engine to enrich the air/fuel mixture to create a condition which is roughly analogous to how chokes worked on carburetted engines to control idling in cold weather.

U2741 Renault 20 Error Code Repair Process :

If your scp (j1850) invalid or missing data for remote button control check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U2741 and engine control unit are in charge of monitoring a bunch of different scp (j1850) invalid or missing data for remote button control, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Renault 20 U2741 OBD2 Code

A common cause of code U2741 is the failure of SCP (J1850) Invalid or Missing Data for Remote Button Control, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty Crankshaft Position Sensor (POS)
Faulty TCM or TCM programming
Faulty spark plug (s)

U2741 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2741 Renault 20 OBD Code

U2741 Renault 20 Error Code Repair Process :

Common Causes of Renault 20 U2741 OBD2 Code

U2741 code for other Renault cars