U2361 Nissan Teana OBD Code

OBD/2 U2361 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

U2361 Nissan Teana Error Code Repair Process :

If your abs inlet valve coil rr circuit short to ground check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U2361 and engine control unit are in charge of monitoring a bunch of different abs inlet valve coil rr circuit short to ground, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Nissan Teana U2361 OBD2 Code

A common cause of code U2361 is the failure of ABS Inlet Valve Coil RR Circuit Short To Ground, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Dirty Oil
1Camshaft Position Sensor circuit poor electrical connection
Lack of fuel

U2361 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2361 Nissan Teana OBD Code

U2361 Nissan Teana Error Code Repair Process :

Common Causes of Nissan Teana U2361 OBD2 Code

U2361 code for other Nissan cars