U2361 Nissan Fusion OBD Code

OBD/2 U2361 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

U2361 Nissan Fusion Error Code Repair Process :

The rule of U2361 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of abs inlet valve coil rr circuit short to ground. Likewise, overriding the OBD U2361 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Nissan Fusion U2361 OBD2 Code

A common cause of code U2361 is the failure of ABS Inlet Valve Coil RR Circuit Short To Ground, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Camshaft advance mechanism binding (VCT unit)
Intake Valve Timing Control Solenoid Valve harness is open or shorted
Clogged or faulty fuel injector (s)

U2361 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2361 Nissan Fusion OBD Code

U2361 Nissan Fusion Error Code Repair Process :

Common Causes of Nissan Fusion U2361 OBD2 Code

U2361 code for other Nissan cars