U228D Mazda Rx-01 OBD Code

OBD/2 U228D error code description and symptoms.

Variable Cam Timing Over-advanced (Bank 1) The comprehensive component monitor (CCM) monitors the VCT position for an over-advanced camshaft timing.
The test fails when the camshaft timing exceeds a maximum calibrated value or remains in an advanced position. Cam timing improperly set No oil flow to the VCT piston chamber Low oil pressure VCT solenoid valve stuck closed Camshaft advance mechanism binding (VCT unit) U228D DTC is a check of the VCT unit.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

U228D Mazda Rx-01 Error Code Repair Process :

The rule of U228D code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of speed wheel sensor lr coherency fault. Likewise, overriding the OBD U228D error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Mazda Rx-01 U228D OBD2 Code

A common cause of code U228D is the failure of Speed Wheel Sensor LR Coherency Fault, but there are several other possible causes as well, such as ;

Camshaft advance mechanism binding (VCT unit)
Continuous oil flow to the VCT piston chamber
Ignition coils harness is open or shorted
Incorrect fuel filler cap used

U228D is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U228D Mazda Rx-01 OBD Code

U228D Mazda Rx-01 Error Code Repair Process :

Common Causes of Mazda Rx-01 U228D OBD2 Code

U228D code for other Mazda cars