U2156 Toyota Windom OBD Code

OBD/2 U2156 error code description and symptoms.

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

Circuit High Input codes like U2156 are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.

U2156 Toyota Windom Error Code Repair Process :

If your rf side repeater lamp output ckt short to battery check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U2156 and engine control unit are in charge of monitoring a bunch of different rf side repeater lamp output ckt short to battery, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Toyota Windom U2156 OBD2 Code

A common cause of code U2156 is the failure of RF SIDE REPEATER LAMP OUTPUT Ckt Short to Battery, but there are several other possible causes as well, such as ;

EVAP canister or fuel tank leaks
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Intake Valve Timing Control Solenoid Valve harness is open or shorted

U2156 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

U2156 Toyota Windom OBD Code

U2156 Toyota Windom Error Code Repair Process :

Common Causes of Toyota Windom U2156 OBD2 Code

U2156 code for other Toyota cars