U2156 Toyota Sienna OBD Code

OBD/2 U2156 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

U2156 Toyota Sienna Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U2156 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If rf side repeater lamp output ckt short to battery so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the rf side repeater lamp output ckt short to battery.

Common Causes of Toyota Sienna U2156 OBD2 Code

A common cause of code U2156 is the failure of RF SIDE REPEATER LAMP OUTPUT Ckt Short to Battery, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Engine Control Module (ECM)
Camshaft Position Sensor harness is open or shorted
Engine Control Module (ECM)

U2156 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2156 Toyota Sienna OBD Code

U2156 Toyota Sienna Error Code Repair Process :

Common Causes of Toyota Sienna U2156 OBD2 Code

U2156 code for other Toyota cars