U1245 Suzuki Alto Vi OBD Code

OBD/2 U1245 error code description and symptoms.

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

U1245 Suzuki Alto Vi Error Code Repair Process :

If your vehicle failed a U1245 test and the U1245 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses u1245 scp (j1850) invalid or missing data for interior environment a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look u1245 scp (j1850) invalid or missing data for interior environment: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Common Causes of Suzuki Alto Vi U1245 OBD2 Code

A common cause of code U1245 is the failure of U1245 SCP (J1850) Invalid or Missing Data for Interior Environment, but there are several other possible causes as well, such as ;

EVAP canister or fuel tank leaks
Faulty oil control valve (OCV)
Damaged camshaft position (CMP) sensor
Faulty Variable Camshaft Timing (VCT) position solenoid

U1245 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U1245 Suzuki Alto Vi OBD Code

U1245 Suzuki Alto Vi Error Code Repair Process :

Common Causes of Suzuki Alto Vi U1245 OBD2 Code

U1245 code for other Suzuki cars