U0797 Mercedes Clk OBD Code

OBD/2 U0797 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the DVOM on the voltage setting. You will want to test the fuses with circuits loaded. Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.

U0797 Mercedes Clk Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U0797 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If injector high sides shorted together so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the injector high sides shorted together.

Common Causes of Mercedes Clk U0797 OBD2 Code

A common cause of code U0797 is the failure of Injector High Sides Shorted Together, but there are several other possible causes as well, such as ;

Damaged VCT phaser
Engine Control Module (ECM)
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Fuel Injectors circuit poor electrical connection

U0797 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

U0797 Mercedes Clk OBD Code

U0797 Mercedes Clk Error Code Repair Process :

Common Causes of Mercedes Clk U0797 OBD2 Code

U0797 code for other Mercedes cars