Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.
On some transmissions, such as automated manual transmissions or automatic transmissions with manual mode, the GSP switch lets the TCM know whether or not the driver has selected automatic or manual function. On manual transmissions, the GSP switch informs the TCM which gear the driver is selecting, and may function as a neutral safety switch, depending on system design. The TCM also uses the gate select position switch to monitor transmission operation. For example, if the driver selects manual mode and selects 3rd gear on an automatic transmission, the TCM may monitor speed sensors to detect clutch and brake slippage.
The rule of U0797 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of injector high sides shorted together. Likewise, overriding the OBD U0797 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.
Difficulty Level (Expert)
|
Repair Time (60 Min.)
|
| Cost Prediction : $ 80-170 |
|
U0797 is a kind of Network Trouble Code
U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason. |
You can view according U0797 DTC for your car model. We selected several models to see obd2 solutions click and view it.
Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.
Copyright 2017 © All rights reserved