P3013 Nissan Az-1 OBD Code

OBD/2 P3013 error code description and symptoms.

The issue covered by the bulletin involves a power steering noise/whine or fluid leak from the power steering pump, gear or high pressure side power steering hose during extreme low outdoor temperature operation.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

P3013 Nissan Az-1 Error Code Repair Process :

The rule of P3013 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of air bag crash sensor #2 ground circuit short to ground. Likewise, overriding the OBD P3013 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Nissan Az-1 P3013 OBD2 Code

A common cause of code P3013 is the failure of Air Bag Crash Sensor #2 Ground Circuit Short To Ground, but there are several other possible causes as well, such as ;

Exhaust gas leaks
Faulty front heated oxygen sensor
Faulty Intake Valve Timing Control Solenoid Valve
Oil flow restriction in the oil passages or the VCT valve body

P3013 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P3013 Nissan Az-1 OBD Code

P3013 Nissan Az-1 Error Code Repair Process :

Common Causes of Nissan Az-1 P3013 OBD2 Code

P3013 code for other Nissan cars