P3013 Nissan 1-tonner OBD Code

OBD/2 P3013 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

P3013 Nissan 1-tonner Error Code Repair Process :

The rule of P3013 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of air bag crash sensor #2 ground circuit short to ground. Likewise, overriding the OBD P3013 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Nissan 1-tonner P3013 OBD2 Code

A common cause of code P3013 is the failure of Air Bag Crash Sensor #2 Ground Circuit Short To Ground, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Dirty Oil
Faulty spark plug (s)
Camshaft advance mechanism binding (VCT unit)

P3013 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P3013 Nissan 1-tonner OBD Code

P3013 Nissan 1-tonner Error Code Repair Process :

Common Causes of Nissan 1-tonner P3013 OBD2 Code

P3013 code for other Nissan cars