P2347 Simca 1308 OBD Code

OBD/2 P2347 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code P2347, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code P2347 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

P2347 Simca 1308 Error Code Repair Process :

The rule of P2347 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of p2347 cylinder 12 above knock threshold. Likewise, overriding the OBD P2347 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Simca 1308 P2347 OBD2 Code

A common cause of code P2347 is the failure of P2347 Cylinder 12 Above Knock Threshold, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty front heated oxygen sensor
Incorrect Positive Crankcase Ventilation (PCV) hose connection
Faulty oil control valve (OCV)

P2347 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P2347 Simca 1308 OBD Code

P2347 Simca 1308 Error Code Repair Process :

Common Causes of Simca 1308 P2347 OBD2 Code

P2347 code for other Simca cars