P07C4 Ford Zephyr OBD Code

OBD/2 P07C4 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

Circuit High Input codes like P07C4 are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.

P07C4 Ford Zephyr Error Code Repair Process :

For wiper hi/low speed relay coil circuit short to ground check engine light is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. P07C4 error code diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks wiper hi/low speed relay coil circuit short to ground with your car's computers to find out exactly what's prompting the light to turn on.

Common Causes of Ford Zephyr P07C4 OBD2 Code

A common cause of code P07C4 is the failure of Wiper Hi/Low Speed Relay Coil Circuit Short To Ground, but there are several other possible causes as well, such as ;

Damaged VCT phaser
Continuous oil flow to the VCT piston chamber
Faulty starter motor
Exhaust gas leaks

P07C4 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

P07C4 Ford Zephyr OBD Code

P07C4 Ford Zephyr Error Code Repair Process :

Common Causes of Ford Zephyr P07C4 OBD2 Code

P07C4 code for other Ford cars