P07C4 Ford Fpv Gt-p OBD Code

OBD/2 P07C4 error code description and symptoms.

Fuel Rail Pressure Sensor in Range But Low The comprehensive component monitor (CCM) monitors the FRP pressure for acceptable fuel pressure. The test fails when the fuel pressure falls below a calibrated value. Low fuel pressure Damaged FRP sensor Excessive resistance in circuit Low or no fuel A FRP PID value below 551 kpa (80 psi) indicates a failure Low or no fuel A FRP PID value greater than 896 kpa (130 psi) indicates a failure.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

P07C4 Ford Fpv Gt-p Error Code Repair Process :

The rule of P07C4 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of wiper hi/low speed relay coil circuit short to ground. Likewise, overriding the OBD P07C4 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Ford Fpv Gt-p P07C4 OBD2 Code

A common cause of code P07C4 is the failure of Wiper Hi/Low Speed Relay Coil Circuit Short To Ground, but there are several other possible causes as well, such as ;

Erratic camshaft position due to low oil pressure
Continuous oil flow to the VCT piston chamber
Improper ignition timing
Fuel Injectors circuit poor electrical connection

P07C4 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P07C4 Ford Fpv Gt-p OBD Code

P07C4 Ford Fpv Gt-p Error Code Repair Process :

Common Causes of Ford Fpv Gt-p P07C4 OBD2 Code

P07C4 code for other Ford cars