DF092 Mercedes Cl 55 OBD Code

OBD/2 DF092 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code DF092, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code DF092 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

DF092 Mercedes Cl 55 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine DF092 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If yaw rate sensor circuit open so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the yaw rate sensor circuit open.

Difficulty Level (Soso)
Level
Repair Time (50 Min.)
Time
Cost Prediction : $ 30-110

Common Causes of Mercedes Cl 55 DF092 OBD2 Code

A common cause of code DF092 is the failure of Yaw Rate Sensor Circuit Open, but there are several other possible causes as well, such as ;
Wrench Tool DF092 is a kind of

DF092 code for other Mercedes cars

You can view according DF092 DTC for your car model. We selected several models to see obd2 solutions click and view it.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved