C2A04 Toyota Windom OBD Code

OBD/2 C2A04 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

C2A04 Toyota Windom Error Code Repair Process :

The rule of C2A04 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of mirror driver vertical switch circuit short to ground. Likewise, overriding the OBD C2A04 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Toyota Windom C2A04 OBD2 Code

A common cause of code C2A04 is the failure of Mirror Driver Vertical Switch Circuit Short To Ground, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Fuel Injectors circuit poor electrical connection
Three way catalyst converter Bank 1

C2A04 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2A04 Toyota Windom OBD Code

C2A04 Toyota Windom Error Code Repair Process :

Common Causes of Toyota Windom C2A04 OBD2 Code

C2A04 code for other Toyota cars