C2A04 Toyota Alphard OBD Code

OBD/2 C2A04 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

C2A04 Toyota Alphard Error Code Repair Process :

The rule of C2A04 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of mirror driver vertical switch circuit short to ground. Likewise, overriding the OBD C2A04 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Toyota Alphard C2A04 OBD2 Code

A common cause of code C2A04 is the failure of Mirror Driver Vertical Switch Circuit Short To Ground, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Engine Control Module (ECM)
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Loss of ground.

C2A04 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2A04 Toyota Alphard OBD Code

C2A04 Toyota Alphard Error Code Repair Process :

Common Causes of Toyota Alphard C2A04 OBD2 Code

C2A04 code for other Toyota cars