C2787 Mitsubishi Lancer Evo 10 OBD Code

OBD/2 C2787 error code description and symptoms.

HO2S Sensor Circuit Malfunction (HO2S-11) During testing the HO2S Heaters are checked for opens/shorts and excessive current draw.
The test fails when current draw exceeds a calibrated limit and/or an open or short is detected. Short to VPWR in harness or HO2S. Water in harness connector. Open VPWR circuit. Open GND circuit. Low battery voltage. Corrosion or poor mating terminals and wiring Damaged HO2S heater. Damaged PCM.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C2787 Mitsubishi Lancer Evo 10 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine C2787 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If wiper washer fluid level sensor circuit open so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the wiper washer fluid level sensor circuit open.

Common Causes of Mitsubishi Lancer Evo 10 C2787 OBD2 Code

A common cause of code C2787 is the failure of Wiper Washer Fluid Level Sensor Circuit Open, but there are several other possible causes as well, such as ;

Exhaust tube
Faulty TCM or TCM programming
Faulty Camshaft Position Sensor
Erratic camshaft position due to low oil pressure

C2787 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2787 Mitsubishi Lancer Evo 10 OBD Code

C2787 Mitsubishi Lancer Evo 10 Error Code Repair Process :

Common Causes of Mitsubishi Lancer Evo 10 C2787 OBD2 Code

C2787 code for other Mitsubishi cars