C2787 Mitsubishi Endeavor OBD Code

OBD/2 C2787 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C2787, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code C2787 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

C2787 Mitsubishi Endeavor Error Code Repair Process :

The rule of C2787 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of wiper washer fluid level sensor circuit open. Likewise, overriding the OBD C2787 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Mitsubishi Endeavor C2787 OBD2 Code

A common cause of code C2787 is the failure of Wiper Washer Fluid Level Sensor Circuit Open, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Camshaft advance mechanism binding (VCT unit)
Variable Camshaft Timing (VCT) position circuit is open or shorted

C2787 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2787 Mitsubishi Endeavor OBD Code

C2787 Mitsubishi Endeavor Error Code Repair Process :

Common Causes of Mitsubishi Endeavor C2787 OBD2 Code

C2787 code for other Mitsubishi cars