C2513 Ford Mondeo 4 OBD Code

OBD/2 C2513 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

C2513 Ford Mondeo 4 Error Code Repair Process :

For tfp valve position switch circuit/ transmission 4-wheel drive low indicator short circuit to battery check engine light is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. C2513 error code diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks tfp valve position switch circuit/ transmission 4-wheel drive low indicator short circuit to battery with your car's computers to find out exactly what's prompting the light to turn on.

Common Causes of Ford Mondeo 4 C2513 OBD2 Code

A common cause of code C2513 is the failure of TFP Valve Position Switch Circuit/ Transmission 4-Wheel Drive Low Indicator Short Circuit To Battery, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Fuel tank leaking
Internal electrical failures in actuator motors/solenoids.

C2513 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2513 Ford Mondeo 4 OBD Code

C2513 Ford Mondeo 4 Error Code Repair Process :

Common Causes of Ford Mondeo 4 C2513 OBD2 Code

C2513 code for other Ford cars