C2513 Ford Ikon OBD Code

OBD/2 C2513 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

C2513 Ford Ikon Error Code Repair Process :

If your tfp valve position switch circuit/ transmission 4-wheel drive low indicator short circuit to battery check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C2513 and engine control unit are in charge of monitoring a bunch of different tfp valve position switch circuit/ transmission 4-wheel drive low indicator short circuit to battery, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Ford Ikon C2513 OBD2 Code

A common cause of code C2513 is the failure of TFP Valve Position Switch Circuit/ Transmission 4-Wheel Drive Low Indicator Short Circuit To Battery, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Damaged camshaft position (CMP) sensor
Variable Camshaft Timing (VCT) position circuit poor electrical connection

C2513 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2513 Ford Ikon OBD Code

C2513 Ford Ikon Error Code Repair Process :

Common Causes of Ford Ikon C2513 OBD2 Code

C2513 code for other Ford cars