C228C Maserati Simun OBD Code

OBD/2 C228C error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

C228C Maserati Simun Error Code Repair Process :

The scent may C228C signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such C228C, so if the inside of your car a/c compressor temperature sensor malfunction as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Common Causes of Maserati Simun C228C OBD2 Code

A common cause of code C228C is the failure of A/C Compressor Temperature Sensor Malfunction, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Damaged camshaft position (CMP) sensor
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Open VPWR circuit

C228C is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C228C Maserati Simun OBD Code

C228C Maserati Simun Error Code Repair Process :

Common Causes of Maserati Simun C228C OBD2 Code

C228C code for other Maserati cars