C1152 Abarth 800 OBD Code

OBD/2 C1152 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C1152, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code C1152 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

C1152 Abarth 800 Error Code Repair Process :

The rule of C1152 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of air suspension lf corner down timeout. Likewise, overriding the OBD C1152 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Abarth 800 C1152 OBD2 Code

A common cause of code C1152 is the failure of Air Suspension LF Corner Down Timeout, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty front heated oxygen sensor
Faulty select solenoid
Incorrect fuel pressure

C1152 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C1152 Abarth 800 OBD Code

C1152 Abarth 800 Error Code Repair Process :

Common Causes of Abarth 800 C1152 OBD2 Code

C1152 code for other Abarth cars