C1077 Daihatsu Move OBD Code

OBD/2 C1077 error code description and symptoms.

Brake Switch Circuit Input Malfunction Indicates PCM did not receive a brake pedal position (BPP) input. Open or short in BPP circuit Open or short in stoplamp circuits Damaged PCM Malfunction in module(s) connected to BPP circuit. (Rear Electronic Module [REM] Windstar and LS6/LS8 or Lighting Control Module (LCM) Continental and Town Car. Damaged brake switch Misadjusted brake switch Check for proper function of stoplamps.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

C1077 Daihatsu Move Error Code Repair Process :

The rule of C1077 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of speed vehicle signal circuit failure. Likewise, overriding the OBD C1077 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Daihatsu Move C1077 OBD2 Code

A common cause of code C1077 is the failure of Speed Vehicle Signal Circuit Failure, but there are several other possible causes as well, such as ;

Failures of clutch motion/travel sensors.
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Faulty Mass Air Flow (MAF) sensor
Oil Control Valve (OCV) circuit is open or shorted

C1077 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C1077 Daihatsu Move OBD Code

C1077 Daihatsu Move Error Code Repair Process :

Common Causes of Daihatsu Move C1077 OBD2 Code

C1077 code for other Daihatsu cars