The Throttle Position sensor signals the Engine Control Module as to the current position of the engine throttle valve.
The current throttle valve opening is based on the driver's input from the gas pedal. The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.
At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.
If your vehicle failed a B209B test and the B209B Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses right rear stop lamp circuit failure a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look right rear stop lamp circuit failure: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.
Difficulty Level (Easy)
|
Repair Time (20 Min.)
|
Cost Prediction : $ 20-50 |
B209B is a kind of Body Trouble Code
Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems. |
You can view according B209B DTC for your car model. We selected several models to see obd2 solutions click and view it.