B209B Daihatsu Consorte OBD Code

OBD/2 B209B error code description and symptoms.

HO2S Sensor Circuit Malfunction (HO2S-11) During testing the HO2S Heaters are checked for opens/shorts and excessive current draw.
The test fails when current draw exceeds a calibrated limit and/or an open or short is detected. Short to VPWR in harness or HO2S. Water in harness connector. Open VPWR circuit. Open GND circuit. Low battery voltage. Corrosion or poor mating terminals and wiring Damaged HO2S heater. Damaged PCM.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

B209B Daihatsu Consorte Error Code Repair Process :

If your vehicle failed a B209B test and the B209B Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses right rear stop lamp circuit failure a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look right rear stop lamp circuit failure: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Difficulty Level (Expert)

Repair Time (35 Min.)

Cost Prediction : $ 20-50

Common Causes of Daihatsu Consorte B209B OBD2 Code

A common cause of code B209B is the failure of Right Rear Stop lamp Circuit Failure, but there are several other possible causes as well, such as ;

• Exhaust tube
• Camshaft advance mechanism binding (VCT unit)
• Fuel injectors harness is open or shorted
• Incorrect fuel filler cap used

B209B is a kind of Body Trouble Code Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems.

B209B code for other Daihatsu cars

You can view according B209B DTC for your car model. We selected several models to see obd2 solutions click and view it.

• B209B Daihatsu Altis
• B209B Daihatsu Applause
• B209B Daihatsu Atrai
• B209B Daihatsu Bee
• B209B Daihatsu Charade
• B209B Daihatsu Charmant
• B209B Daihatsu Compagno
• B209B Daihatsu Copen
• B209B Daihatsu Cuore
• B209B Daihatsu D-compact
• B209B Daihatsu Delta
• B209B Daihatsu Domino
• B209B Daihatsu Esse
• B209B Daihatsu Fellow
• B209B Daihatsu Feroza
• B209B Daihatsu Fourtrak
• B209B Daihatsu Freeclimber
• B209B Daihatsu Fr-x
• B209B Daihatsu Gran
• B209B Daihatsu Kopen
• B209B Daihatsu Leeza
• B209B Daihatsu Materia
• B209B Daihatsu Max
• B209B Daihatsu Micros
• B209B Daihatsu Mira
• B209B Daihatsu Move
• B209B Daihatsu Muse
• B209B Daihatsu Naked
• B209B Daihatsu Opti
• B209B Daihatsu Rocky
• B209B Daihatsu Sirion
• B209B Daihatsu Sonica
• B209B Daihatsu Sp-4
• B209B Daihatsu Sportrak
• B209B Daihatsu Taft
• B209B Daihatsu Terios
• B209B Daihatsu Terios 2
• B209B Daihatsu Trevis
• B209B Daihatsu U4
• B209B Daihatsu U4b
• B209B Daihatsu Yrv

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved