U3911 Holden Hrt OBD Code

OBD/2 U3911 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC U3911 as an indication of a hard fault.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

U3911 Holden Hrt Error Code Repair Process :

If your transmission automatic hall effect sensor power circuit short to battery / 4wd low switch circuit electrical check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U3911 and engine control unit are in charge of monitoring a bunch of different transmission automatic hall effect sensor power circuit short to battery / 4wd low switch circuit electrical, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Holden Hrt U3911 OBD2 Code

A common cause of code U3911 is the failure of Transmission Automatic Hall Effect Sensor Power Circuit Short To Battery / 4WD Low Switch Circuit Electrical, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Dirty Oil
Faulty Air Flow Meter

U3911 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3911 Holden Hrt OBD Code

U3911 Holden Hrt Error Code Repair Process :

Common Causes of Holden Hrt U3911 OBD2 Code

U3911 code for other Holden cars