U3585 Holden Jackaroo OBD Code

OBD/2 U3585 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

U3585 Holden Jackaroo Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U3585 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If unable to bleed up fuel tank vacuum so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the unable to bleed up fuel tank vacuum.

Common Causes of Holden Jackaroo U3585 OBD2 Code

A common cause of code U3585 is the failure of Unable To Bleed Up Fuel Tank Vacuum, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
EVAP canister or fuel tank leaks
EVAP system hose leaking
Oil Control Valve (OCV) circuit is open or shorted

U3585 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3585 Holden Jackaroo OBD Code

U3585 Holden Jackaroo Error Code Repair Process :

Common Causes of Holden Jackaroo U3585 OBD2 Code

U3585 code for other Holden cars