U3585 Daihatsu Gran OBD Code

OBD/2 U3585 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

U3585 Daihatsu Gran Error Code Repair Process :

If your unable to bleed up fuel tank vacuum check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U3585 and engine control unit are in charge of monitoring a bunch of different unable to bleed up fuel tank vacuum, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Daihatsu Gran U3585 OBD2 Code

A common cause of code U3585 is the failure of Unable To Bleed Up Fuel Tank Vacuum, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Failures of clutch motion/travel sensors.
Faulty Intake Valve Timing Control Solenoid Valve
Open circuits caused by corrosion of electrical connectors.

U3585 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3585 Daihatsu Gran OBD Code

U3585 Daihatsu Gran Error Code Repair Process :

Common Causes of Daihatsu Gran U3585 OBD2 Code

U3585 code for other Daihatsu cars